run flat FIAT GRANDE PUNTO 2009 199 / 1.G Owners Manual

Page 111 of 210

110
SAFETY
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
CONTROLS
AND DEVICES
STARTING
AND DRIVING
USING THE MANUAL
GEARBOX
To engage the gears, press the clutch ped-
al down fully and shift the gear lever into
one of the required positions (a diagram
is shown on the knob fig. 2).
IMPORTANT Reverse may be engaged
only when the car is at a standstill. With
the engine running, wait for at least 2 sec-
onds with the clutch pedal fully depressed
before engaging reverse to prevent dam-
age to the gears and grating.
fig. 2F0M0503m
Depress the clutch pedal ful-
ly to change gear correctly.
There should be no obstacles on the
floor underneath the pedals; make
sure that mats are always flat and do
not interfere with the pedals.
WARNING
Do not drive with your hand
resting on the gear lever as
the force exerted, even if
slight, could lead over time to
premature wear of the gearbox inter-
nal components.To engage reverse Rfrom neutral, lift ring
Aunder the knob and at the same time
move the gearshift lever to the right and
then backwards fig. 2.
IMPORTANT The clutch pedal should be
used only to change gear. Do not drive
with your foot resting on the clutch ped-
al, however slightly. For versions/markets
where provided, the electronic clutch
control can intervene if it interprets the
incorrect driving style as a fault.
105-116 ACTUAL 1ed EN 28-08-2009 8:57 Pagina 110

Page 192 of 210

191
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICE
AND CARE
INDEX
CONTROLS
AND DEVICES
TECHNICAL
SPECIFICATIONS
2.2 2.1
2.2 2.2
2.2 2.0
2.2 2.22.2 2.1
2.2 2.2
2.2 2.0
2.2 2.22.4 2.1
2.5 2.2
2.3 2.1
2.3 2.3
PERFORMANCES
Maximum speeds after initial car use, in km/h.
1.2 1.4 1.3 Multijet
155 165 165 COLD TYRE INFLATION PRESSURE (bar)
Versions 1.2 1.4 1.3 Multijet
Front Rear Front Rear Front Rear
175/65 R15 84T
Medium load
Full load
185/65 R15 88T
Medium load
Full load
Add +0.3 bar to the prescribed pressure when the tyres are warm. However, recheck that the value is correct with the tyre cold.
With snow tyres, add +0.2 bar to the pressure recommended for standard tyres.
When running at speeds higher than 160 km/h, inflate tyres to full-load pressures.
181-197 ACTUAL 1ed EN 31-08-2009 12:02 Pagina 191

Page 209 of 210

Fiat Group Automobiles S.p.A. – Customer Services – Technical Services – Service Engineering – Largo Senatore G. Agnelli, 5 – 10040 Volvera – Torino (Italia)
Print no. 603.81.637 – 08/2009 – 1 edition
CHANGING ENGINE OIL
1.2 - 1.4 - 1.3 Multijet 75 HP
Tank capacity45
Reserve5 ÷ 7
Refuel petrol cars only with unleaded petrol with an octane rating (RON) of 95 or higher (EN 228 specifications).
Refuel diesel cars only with automotive diesel (EN 590 specifications).
REFUELLING (litres)
2.2 2.1
2.2 2.2
2.2 2.0
2.2 2.22.2 2.1
2.2 2.2
2.2 2.0
2.2 2.22.4 2.1
2.5 2.2
2.3 2.1
2.3 2.3
1.2 1.41.3 Multijet 75 HP
litres kg litres kg litres kg
Engine sump and filter 2.6 2.25 2.6 2.25 3.2 2.75
COLD TYRE INFLATION PRESSURE (bar)
Versions1.2 1.4 1.3 Multijet 75 HPFront Rear Front Rear Front Rear
175/65 R15 84T
Medium load
Full load
185/65 R15 88T
Medium load
Full load
Add +0.3 bar to the prescribed pressure when the tyres are warm. However, recheck that the value is correct with the tyre cold.
With snow tyres, add +0.2 bar to the pressure recommended for standard tyres.
When running at speeds higher than 160 km/h, inflate tyres at full-load pressures.
198-208 ACTUAL 1ed EN 31-08-2009 12:12 Pagina 208